Table of Contents
Advertisement
The buttons on the left side of the steering wheel
operate the ACC system.
Adaptive Cruise Control Buttons
1 — Distance Button
2 — RES/Set Switch
3 — On/Off Button
•
To Activate/Deactivate
○ Push and release the on/off button.
WARNING!
Leaving the Adaptive Cruise Control (ACC) sys-
tem on when not in use is dangerous. You could
accidentally set the system or cause it to go
faster than you want. You could lose control
and have a collision. Always leave the system
off when you are not using it.
30
INTERIOR
•
To Set A Desired ACC Speed
○ When the vehicle has reached the desired
speed, push the RES/SET switch up or
down briefly, then release.
WARNING!
If the Active Speed Limiter is active, the system
will not react to vehicles ahead. In addition, the
proximity warning does not activate and no
alarm will sound even if you are too close to the
vehicle ahead since neither the presence of the
vehicle ahead nor the vehicle-to-vehicle dis-
tance is detected. Be sure to maintain a safe
distance between your vehicle and the vehicle
ahead. Always be aware which mode is
selected.
•
To Deactivate
○ You can deactivate the ACC by pressing the
on/off button again, placing your vehicle's
ignition in the OFF position or by activact-
ing RACE mode (Quadrifoglio models).
•
To Resume Speed
○ If ACC was canceled, and there is a set
speed in memory, push the RES/SET switch
upward.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming a
set speed that is too high or too low for prevail-
ing traffic and road conditions could cause the
vehicle to accelerate or decelerate too sharply
for safe operation. Failure to follow these warn-
ings can result in a collision and death or seri-
ous personal injury.
•
To Vary The Speed Setting
○ Once the vehicle speed has been set, you
can increase the speed by pushing the RES/
SET switch upward or decrease the speed
by pushing the RES/SET switch downward.
•
Setting The Following Distance In ACC
○ To decrease the distance setting, push the
Distance Setting Button and release. Each
time the button is pushed, the distance set-
ting increases by one bar (longer). Once the
longest setting is reached, if the button is
pushed again it will be set to the shortest
setting available.
WARNING!
•
The maximum braking applied by the system
is limited. The driver may apply the brakes in
all cases if needed.
(Continued)
Advertisement
Table of Contents
