Toshiba RAS-25S4KVDG-ND Service Manual page 82

INFORMATION
• The lower part of indoor unit may float, due to the
condition of piping and installer cannot fix it to the
installation plate. In that case, use the screws
provided to fix the indoor unit with the installation
plate.
• Especially when the pipes are pulled out to the left
side, the indoor unit must be screwed to the
installation plate.
8 8
Screw
<How to remove the air inlet grille>
1. Be careful open the air inlet grille until arm touch the
stopper of the front panel.
2. Insert a screwdriver deeply into the space between
arm of the air inlet grille and the front panel.
Air inlet grille
Front panel
Fig. 10-3-22
3. Pry off the right and left arms of
the air inlet grille by screwdriver.
Support the middle of the air
inlet grille with your hand
while prying its arm on each
side.
4. Remove the safety rope from the
top center of the front panel.
• Press the steel part of the
safety rope then push it out to
back side.
Top center of
the front panel
Fig. 10-3-23
Installation plate 1
Wall
Indoor unit
Screw
Screw 8
Screwdriver
Front panel
Arm of the
air inlet grille
Screwdriver
Press
direction
Push
direction
Safety rope
<How to install the air inlet grille>
1. Insert the left and right arms of the air inlet
grille to the slot holes on the two sides of the
front panel and push in completely.
2. Rotate the grille support as indicated by the
arrows until it stop. then, slowly lower the air
inlet grille and it will be held open by the grille
support.
Support the middle of the wooden grille with
your hand while rotate the grille support to
hold open it.
3. Hook the safety rope into the top center of the
front panel.
• Press the steel part of the safety rope then pull it
to front side.
direction
Safety rope
4. Rotate the grille support down then close the air
inlet grille.
Be sure to press the positions as indicated by
the arrow in order to attach the air inlet grille to
the indoor unit.
CAUTION
• The air inlet grille should be removed before
installing the indoor unit. To avoid damage to
the corner of the air inlet grille or the wall.
• Please install the safety rope after installing
the air inlet grille to the indoor unit.
• It is not recommended to remove the air inlet
grille while the indoor unit is installed. It might
slip out of your hands and cause damage.
- 82 -
Rotate
Grille support
Fig. 10-3-24
Press
2
Pull
direction
Fig. 10-3-25
Fig. 10-3-26
Arrange the
safety rope
follow this
direction