Cleaning Instructions (Thermal Dispensers) - Curtis G4 TPX Series User Manual

CLEANING INSTRUCTIONS
Cleaning the Thermal Dispenser (Daily)
The following cleaners are required to properly maintain the thermal dispenser:
• Mild solution of dish-washing detergent and warm water
™
• TABZ Coffee Equipment Cleaner Tablets*
• One-Pro Beverage Equipment Cleaner
WARNING: DO NOT immerse the dispenser or lid in water or any other liquid. Do not place the dispenser
or lid in a dishwasher. Doing so will void the warranty. Do not use harsh powders or cleansers containing
chlorine. Do not use a wire brush or scouring pad to clean inside the liner. To avoid damage, DO NOT
use a brush to clean the faucet or the inside of the faucet shank (outlet).
IMPORTANT: Some dispensers have a stem on the bottom of the lid with a built-in sensor used for the
®
feature. Keep this stem free from coffee oil build-up for proper operation.
Cleaning the Container
1 Remove the lid. Rinse the dispenser and lid.
Wash - Prepare a mild solution of detergent and warm
water. Wipe the exterior surfaces of the container and
the lid with a sponge moistened with the detergent
solution to remove spills and debris. Using the supplied
with the detergent solution. Use a sponge brush to
scrub out the stainless steel liner.
3 Rinse - Rinse out the liner and lid with clean, warm
water.
4 Sanitize - Reattach the lid, remove the cover and
center the hole under the brew basket on the brewer.
dispensers, drop two TABZ Z61 tablets into the brew
cycle and allow the liner to soak for 5 to 10 minutes
5
6
drain through the faucet. Rinse the lid thoroughly,
pouring water through the brew-through hole and tube,
during rinsing.
* For 1.5 gal./5.7 L dispensers use type Z95 (Curtis PN WC-79000)
For 1.0 gal./3.8 L dispensers use type Z61 (Curtis PN WC-79003)
1.0/1.5 GALLON THERMAL DISPENSER, CLEANING INSTRUCTIONS
one TABZ Z95
continued...
Style varies
Lid
Stem*
WASH
CI5
Cover
Fill tube
*Some versions
or
coffee
see text
SANITIZE
D