Janome Memory Craft 9450QCP Instruction Book page 20

z
w
q
e
w
c
r
t
b
u
y
m ,
x
q
v
n
i
Winding the bobbin
NOTE:
Set the speed control slider at the fastest position (refer
to page 14).
z Pull the thread from the spool.
Hold the thread with both hands and pass the thread
into the guide slot q.
Draw the thread to the left and forward around the
thread guide w.
Draw the thread to the rear and to the right around
and under the guide plate e.
q Guide slot
w Thread guide
e Guide plate
x Firmly pull the thread to the right while holding it with
both hands.
c Put the bobbin r on the bobbin winder spindle t.
r Bobbin
t Bobbin winder spindle
v Pass the thread to the bobbin.
Hold the thread with both hands and wind it around
the bobbin clockwise several times.
b Insert the thread into one of the slits u of the flange
plate y and pull the thread to cut.
y Flange plate
u Slit
n Push the bobbin to the right. The visual touch screen
will show the bobbin winding sign.
m Start the machine.
Stop the machine when the bobbin is fully wound and
stops spinning.
Return the bobbin winder spindle to its original
position.
, Remove the bobbin. Cut the thread with bobbin thread
cutter B i.
i Bobbin thread cutter B
NOTE:
For safety purposes, the machine will automatically
stop 1.5 minutes after starting bobbin winding.
18