Thread Cutter Switch - Janome Memory Craft 9450QCP Instruction Book

q
y
e
r
o
!0

Thread Cutter Switch

If you wish to use the thread cutter switch, insert the
pin connector into the thread cutter switch jack on the
w
machine.
z First make sure the power switch q is off.
x Remove the cable tie w from the cable.
c Insert the machine plug t of the power supply cable
into the machine socket y.
v Insert the pin connector e into the thread cutter
switch jack r on the machine.
b Insert the power supply plug u into the wall outlet i,
and turn the power switch q on.
z
b
t
i
u
After sewing, depress the thread cutter switch o on the
right side of the foot control to trim the both needle and
bobbin threads.
Do not depress the thread cutter switch until the start/stop
button turns green !0 .
o Thread cutter switch
NOTE:
• Threads are trimmed when the thread cutter switch
is depressed for more than 0.5 seconds.
• The thread cutter switch does not work without the
foot control being depressed first.
• Bundle the cables with the cable tie as necessary.
!1
13
q Power switch
w Cable tie
e Pin connector
r Thread cutter switch jack
t Machine plug
y Machine socket
u Power supply plug
i Wall outlet
!1 Cable tie