Battery - KYMCO Bet & Win 250 Manual

16
. BATTERY/CHARGING SYSTEM

BATTERY

Remove the seat and met-in box. ( 2-3)
Remove the battery cover screw and the
battery cover.
Remove the battery.
First disconnect the battery negative (-) cable
and then the positive (+) cable.
＊
When disconnecting the battery positive
(+) cable, do not touch the frame with
tool; otherwise it will cause short circuit
and sparks to fire the fuel.
The installation sequence is the reverse of
removal.
＊
First connect the positive (+) cable and then
negative (-) cable to avoid short circuit.
BATTERY VOLTAGE INSPECTION (OPEN
CIRCUIT VOLTAGE)
Disconnect the battery cables.
Measure the voltage between the battery
terminals.
Fully charged : 13.2V
Undercharged : 12.3V max.
＊
Battery charging inspection must be
performed with a voltmeter.
CHARGING
Connect the charger positive (+) cable to the
battery positive (+) terminal.
Connect the charger negative (-) cable to the
battery negative (-) terminal.
＊
Keep flames and sparks away
•
from a charging battery.
Turn power ON/OFF at the
•
charger, not at the battery terminals to
prevent sparks near the battery.
Charge the battery according to
•
the current specified on the battery.
During quick charging, the
•
battery temperature should not exceed
45℃ .
＊
• Quick charging should only be done in
an emergency.
• Measure the voltage
the battery is charged.
Charging current : Standard : 1.2A
Quick
Charging time : Standard : 5_
Quick
After charging: Open circuit voltage: 12.8V min.
www.PlanDeGraissage.org
60 minutes after
: 5A
10 hours
: 60 minutes
Bet & Win 250
Battery Cover Screw
16-4