Control Panel - Supero AS-1011M-Ni User Manual

AS1011M-Ni User's Manual
Figure 6-1. Chassis: Front and Rear Views
Keyboard Port
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the
JF2 connector on the motherboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF2 on the motherboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF2
can be found in "Chapter 5: Advanced Motherboard Installation."
Drive Bays (behind bezel)
Mouse Port
VGA Port
USB Ports COM1 Port
6-2
Control Panel
Low Profi le PCI Slot Standard PCI Slots
Ethernet Ports