Table of Contents
Advertisement
Section 4 - Configuration
Protocol:
Indicates to which protocol(s) the filter applies.
Source IP address:
Indicates the IP address range and port(s) to which the filter applies.
General Settings
Enable rule:
Toggle this switch to enable the rule.
Name:
Specify a name for the rule. This name is for reference only and does
not affect functionality.
Action:
Choose the action to be taken when the rule is triggered. Choose
Allow or Deny.
Choose which protocol to which the rule will apply. Choose from TCP/
Protocol:
UDP, TCP, UDP, ICMP, or <All>
Choose if the rule should apply to IPv4 or IPv6.
IP version:
Destination IP Address
Set as:
Choose Range or single IP address to enter a specific IP address or
ranges for the destination filter. Choose Subnet to specify a subnet
only.
Start/End IPv4/
If you have selected Range or single IP address, specify an IP address
IPv6 address:
range for the destination filter. To enter a single address, use only the
Start IPv4/IPv6 address field and leave the End IPv4/IPv6 address
field blank.
Subnet IPv4/IPv6
If you have selected Subnet, specify the destination subnet to filter.
address:
D-Link DIR-615+ User Manual
IP Filter Create/Edit
69
Advertisement
Table of Contents
