Table of Contents
Advertisement
Section 4 - Configuration
Enable
Toggle this switch to enable the connection. This is enabled by default.
Connection:
Disabling this feature may disable your Internet connection.
Miscellaneous
NAT:
Toggle this switch to enable Network Address Translation (NAT). This
setting is enabled by default.
Firewall:
Toggle this switch to enable firewall functionality. This setting is
enabled by default.
Ping:
Toggle this switch to enable WAN Ping. This setting is disabled by
default.
Isolate
Toggle this switch to enable connection isolation. This setting is
connection:
disabled by default.
Ethernet
MAC address:
The default MAC address is set to the Internet port's physical interface
MAC address on the router. You can edit that address manually here.
Clone MAC
Toggle this switch to clone the MAC address of the device you are
address of your
using to access the web UI. Note that no two MAC address within the
NIC:
same subnet can be the same.
Restore Default
Click here to restore your router's default MAC address.
MAC Address:
D-Link DIR-615+ User Manual
Dynamic IPv4 (cont)
22
Advertisement
Table of Contents
