Supero AW-4021A-T2 User Manual page 79

Select "Enabled" to allow AMI BIOS to use the S.M.A.R.T. to support hard drive
disk. The options are Disabled, Enabled, and Auto.
32-Bit Data Transfer
Select "Enabled" to activate the function of 32-Bit data transfer. Select "Disabled"
to deactivate the function. The options are Enabled and Disabled.
Hard Disk Write Protect
Select Enabled to enable the function of Hard Disk Write Protect to prevent data
from being written to HDD. The options are Enabled or Disabled.
IDE Detect Time Out (Sec)
This feature allows the user to set the time-out value for detecting ATA, ATAPI de-
vices installed in the system. Options are 0 (sec), 5, 10, 15, 20, 25, 30 and 35.
ATA(PI) 80Pin Cable Detection
This setting allows AMI BIOS to auto-detect the 80-Pin ATA(PI) cable. The options
are Host, Device and Host & Device.
SATA0 IDE Interface
This setting is used to Enable or Disable the serial controller for SATA0.
SATA1 IDE Interface
This setting is used to Enable or Disable the serial controller for SATA1.
First Boot Device From
Use this setting to select the fi rst boot device as being P-ATA or S-ATA.
Confi guration nVidia RAID ROM
RAID Option ROM
This setting is used to Enable or Disable the nVidia ROM. If Enabled, the setting
below will appear.
Master SATA as RAID
This setting is used to Enable or Disable the 3rd Master as RAID.
7-7
Chapter 7: BIOS