Supero AW-4021A-T2 User Manual page 76

A+ Workstation 4021A-T2 User's Manual
Floppy/IDE/SATA Confi guration
Onboard Floppy Controller
Use this setting to Enable or Disable the onboard fl oppy controller.
Floppy A
Move the cursor to these fi elds via up and down <arrow> keys to select the
fl oppy type. The options are Disabled, 360 KB 5 1/4", 1.2 MB 5 1/4", 720 KB
3½", 1.44 MB 3½", and 2.88 MB 3½".
Onboard IDE Controller
There is a single fl oppy controller on the motherboard, which may be Enabled
or Disabled with this setting.
Serial ATA Devices
This setting is used to determine if SATA drives will be used and how many.
Options are Disabled, Device 0, Device 0/1 and Device 0/1/2.
nVidia RAID Setup
nVidia RAID Function
This setting is used to Enable or Disable the nVidia ROM. If Enabled, the set-
ting below will appear.
SATA0/1/2 Primary/Secondary Channel
This setting is used to Enable or Disable the SATA0 Primary, SATA0 Second-
ary, SATA1 Primary, SATA1 Secondary, SATA2 Primary and SATA2 Secondary
channels (six settings total).
Primary IDE Master/Slave
Highlight one of the items above and press <Enter> to access the submenu for
that item.
Type
Select the type of device connected to the system. The options are Not Installed,
Auto, CDROM and ARMD.
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk drive.
The options are Disabled and Auto.
7-4