Table of Contents
Advertisement
Setting the Lane ID
You can set the printer lane ID manually or through the printer driver.
Follow the steps below to set the lane ID manually. When the lane ID is set manually, the value of
the bottom byte in the IP address is automatically set to the same as the value of the set lane ID.
Push the Lane setting button for at least 5 seconds when the printer is in
1
the idle mode.
The printer prints the following message and enters the lane ID setting mode.
Set the third digit of the lane ID assuming decimal expression by pushing
2
the Self-test button.
Assuming the initial setting value to be 0, the value increases by 1 in the following
progression each time the Self-test button is pushed.
The following Paper Jam LED pattern enables you to confirm the selected value.
Repeats flashing as many times as the set value
Push the Lane setting button to fix the setting.
3
The printer moves on to the setting mode for the next digit.
Repeat steps 2 and 3 for the second and then the first digit.
4
After the first digit is set, the printer prints the following message.
If the set lane ID is out of the range of 1-254, the following message is printed. The printer
discards the set value and ends the lane ID setting mode.
44
Lane ID Mode Started
Current ID: xxx
0 1 2 3 4 5 6 7 8 9 0
500 ms
1.5 s
Lane ID is xxx
Press the Lane button to confirm
Press the SelfTest button to cancel
Lane ID Mode Cancel
ID Range error
ID xxx
Advertisement
Table of Contents
