Epson TM-C710 Technical Reference Manual page 79

• Composite:
Separate the data specified to a composite symbol and a 2D symbol with "\ |" or "| \". Describe the
data in the order of the composite symbol and the 2D symbol.
Example: 1234567890\ |012345678905
• Use a Quiet Zone:
The 2D symbol printing position is moved based on the amount of margin.
Make settings of the following items according to the selected [Type].
2
• PDF417
Module Width:
Module Height:
Column:
Step:
Truncation Symbol:
Error Correction Level:
• QRCode
Model:
Module:
Version:
Error Correction Level:
• GS1 DataBar Stacked
Module:
• GS1 DataBar Stacked Omnidirectional
Module:
• GS1 DataBar Expanded Stacked
Module:
Num Of Chars:
❏ The recommended values for the 2D symbols.
Turn on the check box to print the 2D symbol with a composite sym-
bol.
Leaves a blank margin on the right and left side of 2D symbols for
better readability.
Makes settings of the module width for PDF417.
Makes settings of the module height for PDF417 by the ratio to the module width.
Input the number of columns for PDF417.
Input the number of steps for PDF417.
Turn on this check box when making a symbol without the stop code.
Select an error correction level for PDF417. The data can be read even if the part of
the symbol is broken, and restoration ratio becomes higher for bigger numbers.
Select a QRCode model.
Select the width of cell (module) for QRCode.
Specify the version for QRCode. The number of characters that can be converted
into 2D symbols is different depending on the version of QRCode.
Select an error correction level for QRCode. The data can be read if the part of the
symbol is broken and restoration ratio becomes higher in the order of level L, M, Q,
H.
Sets the module width for GS1 DataBar Stacked.
Sets the module width for GS1 DataBar Stacked Omnidirectional.
Sets the module width for GS1 DataBar Expanded Stacked.
Sets the maximum width for GS1 DataBar Expanded Stacked.
Chapter 4 Handling
4
79