Interface Commands; Table 82 Interface Port-Channel Commands - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

Table 81 Command Summary: Configuration Mode (continued)
COMMAND
vlan-stacking
<SPTPID>
vlan-type <802.1q|port-based>
wfq
fe-spq <Q0-Q7>

32.11.4 interface Commands

The following table lists the
Use these commands to configure the ports.

Table 82 interface port-channel Commands

COMMAND
interface port-
channel <port-
list>
bandwidth-
limit
bpdu-control
<peer|tunnel|
discard|netwo
rk>
broadcast-
limit
cable_diagnos
tics
diffserv
dlf-limit
egress set
<port-list>
VES-1616F-3x Series User's Guide
interface port-channel
cir <Kbps>
egress <Kbps>
pir <Kbps>
<pkt/s>
<pkt/s>
Chapter 32 Introducing the Commands
DESCRIPTION
Enables VLAN stacking on the
device.
Sets the service provider's TP
(Tagged Protocol) ID.
Specifies the VLAN type.
Sets the switch to use Weight
Fair Queuing (WFQ) queuing.
Sets the switch to use WFQ to
service all queues for the
Ethernet port.
commands in configuration mode.
DESCRIPTION
Enables a port or a list of ports for
configuration.
Enables bandwidth control on the
port(s).
Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
Sets the maximum bandwidth allowed
for outgoing traffic on the port(s).
Sets the maximum bandwidth allowed
for incoming traffic on the port(s).
Sets how Bridge Protocol Data Units
(BPDUs) are used in STP port states.
Enables broadcast storm control limit
on the switch.
Sets how many broadcast packets the
interface receives per second.
Displays whether a cable is connected
to the port (good) or not (open).
Enables DiffServ settings on the
port(s).
Enables the Destination Lookup
Failure (DLF) limit.
Sets the interface DLF limit in packets
per second (pps).
Sets the outgoing traffic port list for a
port-based VLAN.
P
13
13
13
13
13
P
13
13
13
13
13
13
13
13
13
13
13
13
13
233