Atlas Copco QAS 100 Instruction Manual page 42

ENA ENABLE, the alarm can be activated or
deactivated. ON means always
activated, RUN means that the alarm
has run status. This means it is activated
when the running signal is present.
FC FAIL CLASS, when the alarm occurs
the unit will react depending on the
selected fail class.
The user can scroll to these choices and select one
choice with the SEL button.
After selection of SP the following view will be
visible:
If the correct password is entered, the following view
appears:
Now the user can change the SP of parameter "G-
P>1". This can be done with the scroll buttons. Then
the user has to select SAVE to save the new settings.
To exit the user has to press the BACK button several
times, until the main view appears.
- 42 -
The JUMP button
Instead of navigating through the entire menu, the
user can jump directly to the required parameter, if he
knows the channel number of that specific parameter.
If the JUMP button is pushed the password view will
appear. Not all parameters can be changed by the end-
user. The required password level for each parameter
is given in the set point list.
The following menus can only be reached using the
JUMP button:
– 9000 Software version
– 9020 Service port
– 911X User password
Level 2 and Level 3 passwords can only be set
through the Atlas Copco Utility Software PC
Software.
– 9120 Service menu
– 9130 Single/Split/Three phase
– 9140 Angle comp. BB/G
Use the UP and DOWN buttons to change the settings
and the SEL button to store the new setting.