Lincoln Electric BesterMig 200-S Operator's Manual page 11

11. Positive Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead depending on the
require configuration.
12. EURO Socket: For connecting a welding gun (for
GMAW / FCAW processes).
13. Left Control : Click to select the Ampere /Wire feed
speed / Inductance/ Material Thickness and turn to
set the value of chosen parameter.
Sets the value shown on the left display. Depending on
welding process can be set:
Process Symbol
Wire feed speed WFS: Nominal
m/min value wire feed speed (m/min).
Inductance: Arc control is controlled
by this knob. If the value is higher, the
arc will be softer and during welding
is less spatters.
Current: Setup value output current in
A
amperage [A].
Wire feed speed WFS: Nominal
value wire feed speed (m/min).
m/min
Inductance: Arc control is controlled
by this knob. If the value is higher, the
arc will be softer and during welding
is less spatters.
Material thickness: Value in mm of
welded material.
Current: Setup value output current in
A
amperage [A].
Current: Setup value output current in
A
amperage [A].
14. Voltage/Voltage Trim/Arc Force encoder: Depending
on welding process, this encoder controls:
GMAW
V
Voltage
process
GMAW Voltage trim: during welding you
V+/-
process can adjust voltage.
ARC FORCE: The output current
SMAW is temporarily increased to clear
process short circuit connections between
the electrode and the work piece.
15. Thermal Overload Indicator, It indicates that the
machine is overloaded or that the cooling is not
sufficient.
English
Description
NOTE:

The 'protection indicator light' will come on if the duty
cycle is exceeded. It shows that the inner temperature
is over the permitted level, the machine should be
stopped being used to allow it cool down. Welding can
continue after the 'protection indicator light' is off.

The power source should be switched off when not in
use.

Welders should wear protective clothing and welding
helmet to prevent injury from arc and thermal
radiation.

Care should be taken so as not to expose others to
the welding arc. Use of screening is recommended.

Do not weld near Inflammable or explosive materials.
Rear Panel
1. Gas Connector: Connection for gas line.
2. Power Lead.
3. Power Switch ON/OFF (I/O): Controls the input power
to the machine. Be sure the power source is
connected to the mains supply before turning power
on ("I").
When the machine is switched again on, last welding
process will be recalled.
If the push-button is pushed in GMAW process in, the
output terminals will lived.
During SMAW process, the output terminals are still lived.
9
Figure 3
WARNING
WARNING
WARNING
English