Lincoln Electric BesterMig 200-S Operator's Manual page 10

Power Source Placement and
connections
WARNING
Avoid excessive dust, acid and corrosive materials in the
air.
Keep protected from rain and direct sun when in use
outdoors.
There should be 500 mm space about for the welding
machine to have good ventilation.
Use adequate ventilation when in confined areas.
Figure 1
Controls and Operational Features
Front Panel
Figure 2
1. Left display: Shows value welding current, wire feed
speed, Inductance and material thickness. During
welding shows the actual welding current value.
2. Right display: Depending on the selected function and
the welding process shows the welding voltage in
volts, or voltage trim value or value of Arc Force.
During welding shows the actual output welding
voltage.
3. Input Power indicator: This LED lights up when the
welding machine is ON and is ready to work.
English
4. Wire feed drive / Gas Purge: This switch allows wire
feeding (wire test) and gas flow (gas test) without
switching on the output voltage.
5. Torch Trigger Mode Button (2-Step/4-Step): Change
the function of the torch trigger.
Process Symbol
6. Welding Process Selection Button: Allow to choose
the welding process:
Process Symbol
SMAW (MMA)
GTAW (Lift TIG)
7. Gas Selection Button: Enables the selection of the
type of shielding gas (for Synergic Mode only).
Process Symbol
8. Gas test button: This button allow initiate gas flow
(gas test) without switching on the output voltage.
9. Wire Diameter or Manual Mode Selection Button:
Sets the diameter of the welding wire for Synergic
Mode.
Process Symbol
0.6
0.8
0.9
1.0
10. Negative Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead depending on the require
configuration.
8
Description
2-Step trigger operation turns
welding on and off as direct
response to the trigger. Welding
process starts when the torch
trigger is press.
4-Step mode allows to continue
welding, when the torch trigger is
released. To stop welding, the
torch trigger should be pressed
again.4-step model facilitates to
make long welds.
Description
Manual setting
(MIG/MAG).
Synergy setting
(MIG/MAG). SYN means when
you choose thickness , gas and
diameter, the machine
recommend a current and voltage.
Description
To choose gas shielding or no
gas.
Description
Available wire diameter
depends on choosing
shielding type, type of wire and
welding wire material.
GMAW
GMAW
will
[mm]
gas
English