Table of Contents
Advertisement
Quick Links
Table of Contents
Congratulations on purchasing your new
Hunter® ceiling fan! It will provide comfort
and performance in your home or office for
many years. This installation and operation
manual contains complete instructions for
installing and operating your fan.
We are proud of our work and appreciate
the opportunity to supply you with the best
ceiling fan available anywhere in the world.
Light Kit
12
What to Expect with
Your Installation
7 feet
Downrod
Remote
Control Cradle
Remote Control
14
M3592-01 • 12/14/15 • © 2015 Hunter Fan Company
Tools Needed
30 inches
2
Ladder
3
Wiring
6
9
Operation,
Maintenance & Cleaning
15
16
1
www.HunterFan.com
Mounting Options
Ceiling Bracket
4
Canopy
Blades
10
Troubleshooting
?
?
17
1.888.830.1326
5
11
?
18
Advertisement
Table of Contents
Related Manuals for Hunter Memphis
Summary of Contents for Hunter Memphis
- Page 1 Downrod Wiring Canopy Blades Remote Operation, Control Cradle Light Kit Remote Control Maintenance & Cleaning Troubleshooting M3592-01 • 12/14/15 • © 2015 Hunter Fan Company...
-
Page 2: What To Expect With Your Installation
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company... -
Page 3: Tools Needed
Tools Needed www.HunterFan.com 1.888.830.1326 Pliers Wire Strippers Screwdrivers Ladder Power Drill 9/64” Drill Bit (optional) (optional) If mounting to a support structure, you will also need these tools. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company... -
Page 4: Mounting Options
You need BOTH You need ONLY a Longer a Longer Downrod & Downrod an Angled Mounting Kit *most common M3592-01 • 12/14/15 • © 2015 Hunter Fan Company... -
Page 5: Ceiling Bracket
To avoid possible electrical shock, before 1-888-830-1326. installing your fan, disconnect the power by turning off the circuit breakers to the outlet Refer to warning w.1 on pg. 2 box associated with the wall switch location. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company... - Page 6 Steps 1-5 to remove standard downrod pipe Longer Downrod for angled ceilings or ceilings 10’ or higher Shorter Downrod for fans installed close to ceiling Steps 6-10 to reassemble with new pipe M3592-01 • 12/14/15 • © 2015 Hunter Fan Company...
- Page 7 4-5 full turns) until it stops. with pliers. DO NOT can be inserted. from the top of the downrod. HAND TIGHTEN. 8” 3/8” If the setscrew is not tightened securely, the fan may fall. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company...
- Page 8 Put the wires and downrod through the canopy. Let the canopy sit loosely on top CANOPY OR WIRES. Place the downrod of the fan. ball into the slot in the ceiling bracket. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company...
- Page 9 Spread the wires apart, with the grounded wires on one side of Refer to CAUTION c.1 on pg. 2 the outlet box and the ungrounded wires on the other side of the outlet box. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company...
- Page 10 Lift the canopy into place so that Insert the two canopy screws lifted into place, the canopy fits into the screw holes are aligned. found in the hardware bag. the hanging bracket as shown. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company...
- Page 11 Put the blade washers found in the hardware bag onto the blade screws found in the hardware bag. Then install the blade screws to secure each blade to a blade iron. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company...
-
Page 12: Light Kit
It does not matter tighten all three screws. which two screw holes you choose. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company... -
Page 13: Operation Instructions
Attach the globe by lifting and twisting See next page for remote black wire from the light kit. counterclockwise until it rests firmly in place. operation instructions. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company... -
Page 14: Remote Control
If three beeps sound, the remote was unpaired. Re-pair using the steps above. To prevent faulty operation, please disconnect power from all other ceiling fans within range while pairing. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company... -
Page 15: Option 1: Using Screws
Press the cradle bracket the back of the adhesive against the wall and hold Install the cradle bracket to the wall with strip on the cradle bracket. firmly for 30 seconds. the included screws. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company... - Page 16 Press and quickly release the light button on the remote control to turn the light OFF or ON. Press and hold the light button for continuous dim. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company...
-
Page 17: Download The App
Note: The HomeKit identification number is located on the front cover of the English side of the Parts Guide. Follow the onscreen prompts to set up your fan. SIMPLEconnect connects to available 2.4 GHZ WiFi networks. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company... -
Page 18: Troubleshooting
Compatible with iOS 7.1 or higher / Android 4.3 or higher this issue. Android and Google Play are trademarks of Google Inc. Apple logo is a trademark of Apple, Inc. App store is a service mark of Apple, Inc. M3592-01 • 12/14/15 • © 2015 Hunter Fan Company...