Setting The Chassis On A Desktop - Cisco VG410 Hardware Installation Manual

Installing the Cisco VG410 Voice Gateway
Figure 9: Front Mounted in Rack
Statement 1006 Chassis Warning for Rack-Mounting and Servicing
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions
to ensure that the system remains stable. The following guidelines are provided to ensure your safety:
Statement 1047 Overheating Prevention
Warning
To reduce the risk of fire or bodily injury, do not operate the unit in an area that exceeds the maximum
recommended ambient temperature of: 40 degrees C.

Setting the Chassis on a Desktop

After unpacking your device, you can place it on a desktop, bench top, or a shelf. However, be aware of the
following before you set your chassis on a desktop:
• Do not place anything on top of the router that weighs more than 10 pounds (4.5 kg), and do not stack
• To prevent airflow restriction, allow clearance around the ventilation openings to be at least 1 inch
• After you install the voice gateway, you must connect the chassis to a reliable earth ground.
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
unit in the rack.
the gateway hardware on a desktop. Excessive distributed weight of more than 10 pounds, or pound point
load of 10 pounds on top could damage the chassis.
(2.54cms). Statement 1076.
Cisco VG410 Voice Gateway Hardware Intallation Guide
Setting the Chassis on a Desktop
23