Cisco VG410 Hardware Installation Manual page 27

Installing the Cisco VG410 Voice Gateway
• Back mounting: Brackets attached at the back of the chassis (PSU and fanside) with the back panel
• Mid-mount: By reversing the orientation of the brackets, mid-mounting of the chassis can be achieved
Perform the following steps to mount the device on the rack:
Step 1 Attach the mounting brackets to the chassis as shown in the following images, using the screws provided.
Do not over-torque the screws. The recommended torque is 15 to 18 inch-lb (1.7 to 2.0 N-m)
Caution
Figure 5: Attach the Mounting Brackets
Step 2
Attach the second bracket to the opposite side of the chassis. Use a number-2 Phillips screwdriver to install the number-6
bracket screws.
Your chassis installation must allow unrestricted airflow for chassis cooling.
Attention
Step 3 Use the screws provided with the rack to install the chassis in the rack. For the 19-inch EIA brackets, start the lower pair
of screws first, and rest the brackets on the lower screws while you insert the upper pair of screws.
See the following images that show the mounting positions from the I/O side, mid mount, and from the power socket
side, respectively.
Figure 6: I/O Side Mounting
facing forward.
with either orientation.
Mounting the Voice Gateway in Rack
Cisco VG410 Voice Gateway Hardware Intallation Guide
21