Advertisement
W
iring diagram
Fig. D-3
Terminal
Rib A
Do not put any lead
wires on this boss.
Controller
Set Controller in place with Flag receptacles faced
as drawn above.
Line extended from Rib D
The bottom of Housing L
viewed from the upper side
BHR242, BHR243
Black
lead wire
White
lead wire
Stator
Flag receptacles
Rib B
Route the lead wires between Connector and Controller to the bottom of Housing L
so as not to rise on the top line of Rib C. Turn them back to set Connector in place.
Place the turned portion over the line extended from Rib D.
Controller
Connect Lead wires to Controller/ Terminal
with Flag receptacles as drawn below.
Flag receptacles
Orange
lead wire
Controller
Slacks of Lead wires between Controller and
Connector/ Stator have to be placed over the line
extended from Rib D.
Rib D
Do not put Stator lead wires on Rib C.
Rib C
Lead wires to Connector have to be routed
between Rib B and Rib D.
Connector
Lead wires to Connector and Stator lead wires
have to be routed between Rib A and Rib B.
Black
lead wire
Red
lead wire
Terminal
Line extended from Rib D
Turned portion
Rib D
Connector
Rib C
P 24/ 25
Advertisement
