Wiring Diagram - Makita HP332D Technical Information

W
iring diagram
Fig. D-2
The following lead wire have
to be put under Stator's lead
wires (orange), (white), (blue).
* Lead wires of LED light
circuit
* Lead wires of Printed
wiring board
Pu the following lead wires
between Rib B and Boss B.
* Stator's Lead wires
* Lead wires of Printed
wiring board
* Lead wires of LED light
circuit
Stator's lead wires (orange),
(white), (blue) have to be
tightened between Boss B
and Stator.
Bullet terminal (3 pcs.)
Bullet terminal (3 pcs.) can be
put to the place, designated
with gray color.
But be careful, not to put
more than 2 pcs. of them
closely by Noise suppressor.
Put lead wires, connected
to Terminal, between Rib D
and Rib E.
Printed wiring board
Stator
Rib B
Boss B
Controller
Rib D
Rib E
Put lead wires of printed wiring board
keeping the distance from Rib C.
Switch
Rib A
Boss C
Noise suppressor
Terminal
P 19/ 20
Rib C
Boss A
Do not put lead wires of
printed wiring board onto
Rib A.
Put lead wires of LED light
circuit between Rib A and
Boss A, and guide them
through the route between
Rib C and Rib A.
Put Lead wire (red),
connecting Switch
and Terminal, between
Boss C and the inner
wall of Housing set L.