Wiring Diagram; Motor Housing - Makita HR3541FC Technical Information

W
iring diagram
Fig. D-2
Controller
(A) Rib for Controller
HR3540C
(B) Rib of Motor
housing
Lead wire of
Power supply cord
Power supply cord
Lead wire holder
Rib
HR3541FC
Rib for Controller
Lead wire of
Light circuit
(B) Rib of
controller
(C) Rib A of

Motor housing

Rib B of
Motor housing
Route Lead wire of Light circuit between (B) and (C).
Do not put Lead wire of Light circuit on the Rib B of Motor
housing.
Motor housing
Dial
Cord guard
Do not put the Lead wires of Power supply cord
on the Ribs (A) and (B).
Motor housing (Bottom view)
Controller
Rib
Rib
LED Circuit
Motor Housing (Rear View)
Controller
Dial
Do not slack the Lead wires in this area.
Fix them with Lead wire holders and Ribs.
Switch
Rib
Connector of
Lead unit
Lead unit
Route the Lead wire as
illustrated on left. Fix it
with Lead wire holder.
Do not slack it between
LED circuit and Lead
wire holder.
Motor Housing (Rear View)
(after assembling Cord Clamp Base)
Rib for Controller
Rib of Motor housing
Cord clamp
base
* Put the extra portion of the Lead wire of Light
circuit into the space between Rib of Motor
housing and Rib for Controller.
* Put Connector into Cord clamp base.
P 18/ 19
Handle
Lead wire holder
Rote the Lead wires of Lead unit
through the opening of Handle.
Controller
Connector