Yamaha MTM690 2022 Owner's Manual page 30

Instrument and control functions
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
4
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to "
the switch down towards " ". See
page 6-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch "OFF/ "
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
signal lights). The hazard lights are
used in case of an emergency or to
EAU12461
/ "
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
". When
The hazard lights can be turned on or
off only when the main switch is in the
"ON" position. You can turn the main
switch to the "OFF" or "LOCK" posi-
tion, and the hazard lights will continue
to flash. To turn off the hazard lights,
EAU12501
turn the main switch to the "ON" posi-
tion and operate the hazard switch
again.
EAU54213
/ / "
NOTICE
Do not use the hazard lights for an
", and then push
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
" to stop the en-
"TRIP/INFO" switch
This switch is used to make setting and
display changes in the multi-function
meter unit. See page 4-5 for more in-
EAU88273
formation.
To use the "TRIP" switch, move the
"TRIP/INFO" switch in direction (a)
(same function as button B on the mul-
tifunction meter).
To use the "INFO" switch, move the
"TRIP/INFO" switch in direction (b)
(same function as button A on the mul-
tifunction meter).
ECA10062
1. "TRIP/INFO" switch
EAU94362
4-12
(a) (a) (a)
(b) (b) (b)
1