Table of Contents
Advertisement
Schedule setting using Mouse
1.
Select a camera first and click on desired start time block (no number on it) on a time bar.
At this time, the selected time block will be highlighted with a yellow frame and the
entire time bar will be highlighted with a red frame.
2.
Click the desired start time block again to confirm, and this block (shows a new sequence
number on it) and all the following blocks will turn to gray. This means the grey time
blocks has been set to No Recording mode.
3.
To change the time blocks to different record mode (which shows a different color),
users need to click again on the block (with number on it) of any section. Every time the
user clicks the first block of a section, the color switches from gray->pink ->blue-green.
4.
Repeat the above steps to configure the record modes. You can configure up to six
record modes on each time bar.
Click the "Edit Timezone" button to edit the recording parameters for a time zone.
Editing Timezone:
From: Displays time zone start time.
To: Displays time zone end time.
Record: Displays Record mode.
Resolution: Recording resolution is displayed.
Normal: Frame rate in FPS for continuous recording. It is important to keep track of the
normal recording resources being allocated at each hours of the day. Increasing the Normal
recording resolution and/or rate can inadvertently request more recording resources than the
DVR is capable of delivering, or allocate so much of the DVRs resources that there is no excess
available for increased FPS rate and/or resolution in response to an Event.
The speed is limited by the maximum total recording capacity of the DVR as allocated across
TV standard in global setting, all the installed cameras.
Since EverFocus DVRs have the capability to change the FPS rate in response to events, it may
be advisable to reserve some recording capacity for event response.
112
ECOR FHD 16x1 DVR
Advertisement
Table of Contents
