How To Use - Panasonic ER-GD61 Operating Instructions Manual

• When the appliance is charged for the first time or it
has not been in use for more than 6 months, the
charging time may change or the charge status lamp
may not glow in the first few minutes. In addition, the
operating time may become shorter. Please charge it
for more than 8 hours in such cases.
• Recommended ambient temperature for charging
is 0 °C – 35 °C. The charging time may change or
battery performance may decrease outside of the
recommended temperature.
• A full charge supplies enough power for approximately
50 minutes of use. (Based on using at 20 °C – 30 °C.)
The operating time may differ depending on the
frequency of use and the operating method.
• You can charge the battery before it is completely
discharged. However, it is recommended to charge
when the battery is completely discharged. The battery
life depends strongly on factors such as how it is used
and stored.
AC operation
If you connect the AC adaptor to the appliance in the
same way as for charging, and turn on the power, you
can use it.
• The battery will be discharged, even with the AC operation.
• If the remaining battery is too low, the blades may
move slowly or stop, even with the AC operation. In
this case, charge the battery for 1 minute or more.
10
PB018141 - ER-GD61 _(01GB)_08-30-19.indd 10

How to use

• Apply the oil to the blade before and after each use.
(See page 14.)
• The appliance may not operate in an ambient
temperature lower than approximately 0 °C.
• Please clean the appliance after each use.
(See pages 12 and 13.)
<Note before trimming>
• Make sure that the main body is turned off.
• Check that the blades are not damaged or deformed
before use.
• Do not use with shaving foam applied or when the
beard is wet.
A wet beard may stick to the skin or bunch up, making
it difficult to trim.
• Before trimming, comb your moustache with a comb.
1
Remove the protective cap. (See page 11.)
2
Select the desired attachments, then press the
power switch to turn on the power and trim.
• Use the appropriate attachment as needed.
It can also be used without the attachment.
● Without the attachment (See page 11.)
● Trimming height comb attachment (See page 11.)
● Detail trimming attachment (See page 12.)
3
Turn off the switch after use.
2019/8/30 14:18:32