D-Link DIR-825+ User Manual page 86

Section 3 - Configuration
My IPv6 Select IPv6 In IPv4 Tunnel if you wish to configure your router to
Connection is: connect to your ISP using 6 to 4. 6 to 4 is an IPv6 address assignment
and automatic tunneling technology that is used to provide unicast
IPv6 connectivity between IPv6 sites and hosts across the IPv4
Internet.
WAN IPV6 ADDRESS SETTINGS
6to4 Address: The current 6to4 address is displayed here.
6to4 Relay: Enter the 6 to 4 relay address supplied by your ISP.
Primary DNS Enter the primary DNS server address.
Address:
Secondary DNS Enter the secondary DNS server address.
Address:
LAN IPv6 Address Settings
LAN IPv6 Address:
Enter the LAN (local) IPv6 address for the router.
LAN IPv6 Link-
Displays the router's LAN link-local address.
Local Address:
D-Link DIR-825+ User Manual
IPV6 CONNECTION TYPE
6to4
DIR-825+
IPV6
IPV6
Use this section to configure your IPv6 Connection Type.If you are unsure of your connection method, please contact your Internet
Service Provider.
Save Settings
IPV6 CONNECTION TYPE
Choose the mode to be used by the router to connect to the IPv6 Internet.
WAN IPV6 ADDRESS SETTINGS
Enter the IPv6 address information provided by your Internet Service Provider (ISP).
LAN IPV6 ADDRESS SETTINGS
Use this section to configure the internal network settings of your router. If you change the LAN IPv6 Address here, you may need to
adjust your PC network settings to access the network again.
ADDRESS AUTOCONFIGURATION SETTINGS
Use this section to setup IPv6 Autoconfiguration to assign IP addresses to the computers on your network.
Enable Automatic IPv6 address assignment :
Save Settings
SETUP
IPV6
Don't Save Settings
My IPv6 Connection is: 6to4
6to4 Address :
6to4 relay :
Primary DNS Address :
Secondary DNS Address :
LAN IPv6 Address : XXXX:XXXX:XXXX: ::1 /64
LAN IPv6 Link-Local Address : ffff::fff:ffff:ffff:1234 /64
☑
Autoconfiguration Type : SLAAC+RDNSS
SLAAC+Stateless DHCP
Stateful DHCPv6
Router Advertisement Lifetime : (minutes)
Don't Save Settings
▼
▼
82