C6097A,B PRESSURE SWITCHES
L1
POSITION
INDICATION
LAMP
L2
Fig. 5. Wiring the Position Indicator Lamp Kit
in the C6097A.
POSITION
INDICATION
LAMP
L2
L1
M16525
Fig. 6. Wiring the Position Indicator Lamp Kit in the
Position Indicator Lamp Operation
The Position Indicator Lamp will light when the C6097
Pressure Switch opens and provides power to the lamp (see
Fig. 5or 6). An option alarm circuit can also be connected as
shown in the same figures.
WIRING
WARNING
Electrical Shock Hazard.
Can cause serious personal injury or death.
Disconnect power supply before beginning installation.
More than one disconnection can be involved.
Make sure that all wiring agrees with all applicable local codes,
ordinances and regulations. An opening is provided to
accommodate rigid conduit or armored cable for line voltage
operation (see Fig. 3 and 4). Do not overload the switch
contacts (see Switch Ratings in the Specifications section).
The switching schematic is shown in Fig. 5.
65-0237—04
C6097A
NO
C
FLAME
NC
SAFEGUARD
CONTROL
(RM78XX)
M16524
FLAME
C6097B
SAFEGUARD
C
NO
CONTROL
(RM78XX)
NC
C6097B.
Fig. 7. C6097 (manual reset switch model)
Fig. 8. C6097 (recycle model) with cover removed.
SETTINGS AND ADJUSTMENTS
Pressure Setpoint Adjustment
To adjust the pressure setting, turn the setpoint adjustment dial
(Fig. 3, 4 and 5) clockwise
setting and counterclockwise
the pressure setting.
6
with cover removed.
to increase the pressure
to decrease