14.4.1 Changing GPS Information to Vessel position or COG
Allows customizing the NAV data showing GPS Information. Factory default is
"Your Vessel's Current Position," however, following the steps below the GPS
Information can be changed to "Course Over Ground (COG)."
1. Press and hold down the [ CALL ( MENU )] key until "
SETUP
" menu appears.
2. Press the [ ENT ] key, then select "
[ ] / [ ] key.
3. Press the [ CALL ( SET ) MENU ] key.
4. Press the [ ] or [ ] key to select "
rent Position)" or "
5. Press the [ ENT ] key to store the data entered, then press
the [ 16/9 ] key to exit this menu and return to radio operation
mode.
14.4.2 External Speaker AF Selection
AF SELECT
The
External Speaker to "fixed" regardress the VOL level setting of the VH-310,
which is useful to the case when use with the amplified speaker, such as the
Standard Horizon MLS-310.
1. Press and hold down the [ CALL ( MENU )] key until "
Setup
" menu appears.
2. Press the [ ENT ] key, then select "
[ ] key.
3. Press the [ ENT ] key.
4. Press the [ ] or [ ] key to select "
Level is "Fixed") or "
able").
5. Press the [ ENT ] key to store the data entered, then press
the [ 16/9 ] key to exit this menu and return to radio operation
mode.
GX1500S
Cru
(Course Over Ground)."
menu allows you to set the audio output level of the VH-310's
Po
" (External Speaker Level is "Adjust-
NAV DISPLAY
" with the
Pos
(Your Vessel's Cur-
" with the [ ] /
AF SELECT
Pr
" (External Speaker
RADIO
Radio
Page 77