Vga Module - Dell OptiPlex Tower 7010 Owner's Manual

Steps
1. Using a screwdriver, remove the serial module cover from the chassis.
NOTE: This step is applicable only when the serial module is being installed for the first time.
2. Connect the serial-module cable to the connector (KB_MS_SERIAL) on the system board
3. Insert the serial module into the slot on the chassis.
4. Replace the two (4-40x6.5) screws that secure the serial module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in

VGA module

Removing optional VGA module
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
after working inside your
before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs) 87