Optional Input/Output Modules; Serial Module - Dell OptiPlex Tower 7010 Owner's Manual

Optional Input/Output modules

Serial module

Removing the optional serial module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the optional serial module and provides a visual representation of the removal
procedure.
Steps
1. Remove the two (4-40x6.5) screws that secure the optional serial module to the chassis.
2. Disconnect the optional serial module cable from the connector on the system board.
3. Lift the optional serial module off the system board.
Installing the serial module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the serial module and provides a visual representation of the installation procedure.
86 Removing and installing Field Replaceable Units (FRUs)