Unpacking The Subscriber Unit; Site Preparation And Precautions - Siemens RUGGEDCOM WIN5149 Installation Manual

Hide thumbs Also See for RUGGEDCOM WIN5149:
Table of Contents

Advertisement

RUGGEDCOM WIN5149
Installation Guide
2.
Unpack and inspect the subscriber unit components. For more information, refer to
the Subscriber
3.
Mount the subscriber unit to a pole, wall or tower. For more information, refer to
Subscriber
Unit".
4.
Install and connect the antenna(s). For more information, refer to
5.
Assemble the PoE cable. For more information, refer to
6.
Make sure the subscriber unit is grounded. For more information, refer to
Subscriber
Unit".
7.
Connect the subscriber unit to a power source and the network. For more information, refer to
"Connecting Power and
8.
Seal all cable connections. For more information, refer to
9.
Configure the subscriber unit. For more information, refer to
Section 2.2

Unpacking the Subscriber Unit

The following items are included in the RUGGEDCOM WIN5149 package:
RUGGEDCOM WIN5149 Subscriber Unit
RUGGEDCOM WIN1010 AC Power Injector
Radio Frequency (RF) antenna cables, 5 m (16.4 ft) long
Pole/wall/tower mounting kit
RJ45 PoE Connector Kit
When unpacking the subscriber unit, do the following:
1.
Inspect the package for damage before opening it.
2.
Visually inspect each item in the package for any physical damage.
3.
Verify all items are included.
If any item is missing or damaged, contact Siemens for assistance.
Section 2.3

Site Preparation and Precautions

Before installing the subscriber unit and or antenna(s), it is important to plan the the complete installation and
make sure the appropriate safe guards are in place.
Site Selection
Consider the following recommendations when selecting an appropriate site for the subscriber unit and
antenna(s):
Unpacking the Subscriber Unit
Unit".
Data".
Item
Section 2.6, "Installing the
Section 2.8.4, "Assembling the PoE
Section 2.7, "Grounding the
Section 2.9, "Weatherproofing the Subscriber
Section 3.1, "Configuring the Subscriber
Chapter 2
Installing the Subscriber Unit
Section 2.2, "Unpacking
Section 2.5, "Mounting the
Antennas".
Connector".
Section 2.8,
Unit".
Unit".
Quantity
1
1
2
1
1
9

Advertisement

Table of Contents
loading

Table of Contents