Before Using For The First Time; Performing Initial Start-Up; Water Softening System - Siemens SN67ZX86DM Information For Use

Place the glassZone in the top
5.
basket and lock in position
Check that the mounts are in the
correct position.
a The glassZone audibly clicks into
position ⁠ .
Push in the top basket.
6.
first time
9 Before using for the
first time
first time
9.1 Performing initial start-up
On initial start-up or after a reset to
the factory settings, you will need to
make settings. The display shows the
settings for initial start-up.
Tip: Connect your appliance to a mo-
bile device. You can conveniently
change all settings via the
Home Connect app.
Requirement: The appliance has
been installed and connected.
→ Page 12
Add special salt. → Page 28
1.
Add rinse aid. → Page 30
2.
Switch on the appliance.
3.
a The display shows the settings for
initial start-up.
Press
4.
⁠ . shows the required setting.
Note: If you select Initial start-up
Home Connect here, make further
settings using the Home Connect
app on your mobile device.
You can change the settings for
initial start-up and other Basic set-
tings → Page 37 on the appliance
at any time or use the Home Con-
nect app on your mobile device.
Press
5.
display shows the right value.
You can change several settings.
To save the settings, press
6.
approx. 3 seconds.
Add detergent → Page 31.
7.
Start the Programme with the
8.
highest cleaning temperature
without tableware.
To remove any marks from water
or other residues, we recommend
you operate the appliance without
tableware before using it for the
first time.
10 Water softening sys-
tem
Hard water leaves limescale on the
tableware as well as the washing
tank, and parts of the appliance may
become blocked.
To ensure good dishwashing results,
you can treat the water with special
salt and the water softening system.
To avoid damage to the appliance,
water with a hardness above 9 °E
must be softened.
first time en
repeatedly until the display
or repeatedly until the
for
27