Troubleshooting - Bissell SPOTBOT 2114 Series User Manual

Troubleshooting

WARNING
To reduce the risk of electric shock, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
Problem
AUTOMATED CLEANING
SpotBot® will
not run
Unusual or
odd noise
Reduced or
no spray
No suction
MANUAL CLEANING
Cleaner will
not run
Unusual or
odd noise
Reduced or
no spray
No suction
14
www.BISSELL.com
Possible causes
Power Cord not plugged in
Blown fuse/tripped breaker
Vacuum Flex Hose is not snapped
into place securely
Clean Water/Solution Tank is
out of fluid
Clean Water/Solution tank is out
of fluid
Clean Water/Solution tank is not
inserted into the unit securely
Tank is full
Dirty Water Tank latch
is not down
Black valve on the Dirty
Water Tank is missing
Power Cord not plugged in
Blown fuse/tripped breaker
Hose not removed from receiver
SpotBot® shut OFF automatically
during use
Clean Water/Solution Tank is
out of fluid
Spray tip clogged on Tough Stain
Tool
Clean Water/Solution Tank is out
of fluid
Clean Water/Solution Tank is not
inserted into the unit securely
Tank is full
Dirty Water Tank latch is not down Push latch down, securely into place
Black valve on the Dirty
Water Tank is missing
Remedies
Check electrical plug
Replace household fuse or reset breaker
Check to make sure the Vacuum Flex
Hose is snapped into place
Fill tank
Fill tank
Gently press the tank until you see
"bubbles" coming from the base
Empty tank
Push latch down, securely into place
Replace black valve onto tank
Check electrical plug
Replace household fuse or reset breaker
Remove hose
Press Pause/Resume button to resume
manual cleaning
Fill tank
Clean spray tip
Fill tank
Gently press the tank until you see
"bubbles" coming from the base
Empty tank
Replace black valve onto tank