Philips M32 107E4 GS 3 Service Manual page 70

66
M32 107E4 GS_3
Go to cover page
3.6
3.6.1
3.6.2
3.6.3
3.7
3.8
3.9
17" M32 GS3 107E4-70K CMTR
TYPE
BRAND : PHILIPS
2002-04-26
JIM LIN
GENERAL PRODUCT SPECIFICATION
RGB Amplifier
Video amplifiers
Dot Rate
Over / undershoot
Sag
Black level shift
Brightness and Contrast
Reference mode 68.7 KHZ/85 HZ full white pattern.
DISPLAY LIGHT OUTPUT
Light output
Brightness Contrast
Minimum Minimum not visible
Center Maximum
100mmx100mm block
Brightness at center and contrast at maximum light output is 41+/-6 FL.
sRGB : When sRGB is selected, the light output (Full white pattern) will be 23 +/- 3 FL
regardless of main contrast and brightness controls. Adjusting contrast or brightness will
auto exit sRGB setting and go to 6500K.
Raster light output
Apply 68.7KHz/85Hz mode with no video pattern, set brightness at center click(50%)
and contrast control at minimum
The light output on the screen center should < 0.2FL.
Variation of image size ( For preset modes only )
Due to brightness change
(Set brightness control at center click(50%), turn contrast control from Min. to Max.)
Due to aging
(25 C, 300 hrs)
Due to mains voltage
variation ( 10% ) : 1.0 %
Degaussing
An automatic degaussing circuit is provided which requires no intervention.
The degaussing activated at the time of switch on or switch on again after switching off
degaussing circuits for longer than 30 minutes.
Phosphor protection
The display device is sufficiently protected against the burning of phosphors in case of
repetitive power cycling or absence of horizontal deflection.
: 107E41/00C
2002-04-26
: 108 MHz
: 15% Max.
(Transient response)
: 5% Max.(pulses of 0.70H)
: 5% Max.
(full white)
30 5 FL.
: 1.0 % max
: 1.0 %
8639 000 12205
590
29
14