Table of Contents
Advertisement
M32 107E4 GS_3
26
Go to cover page
Step 9: Load DDC data
1.
Click
from the tool bar.
2.
Select the file you want to open as shown in Fig. 20.
3.
Click Open.
4.
Access "Factory Mode" and enable "Software DDC only" as shown
in Fig. 17 & Fig. 16.
5.
Write EDID (click
).
107E4_M32.DDC
107E4_M32.DDC
Step 10: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 21.
(EDID Tool 3.01)
Note1 : In User Mode: Read DDC data only
Before read EDID code, please confirm that the Software
DDC only was disabled as shown in Fig. 22.
If you do not disable "Software DDC only", when you execute
"read EDID", it will bring up an error message as below.
DDC Instructions (Continued)
Note 2 : In Factory Mode: Read/Write DDC data
Fig. 20
Fig. 21
Fig. 22
Before Read/Write EDID code, please confirm that the
Software DDC only was enabled as shown in Fig. 23.
Fig. 23
Advertisement
Table of Contents
