Table of Contents
Advertisement
12. ALL
Press and hold ID SET until the ID setting
indicator lights up. Press ALL to clear current
ID setting of the remote control. The ID is
cleared successfully when you see the ID
setting indicator starts flickering and then
blackout.
13. ZOOM+/ZOOM-
Magnifies or reduces the projected picture
size.
14. ID setting indicator
15. QUICK INSTALL
No function.
16. INFO
Displays the projector information.
17. LIGHT SOURCE
Selects an available light mode.
18. BLANK
Used to hide the screen picture.
Do not block the projection lens from
projecting as this could cause the blocking
object to become heated and deformed or
even cause a fire.
Remote control effective range
The remote control must be held at an angle within 30 degrees perpendicular to the projector's IR
remote control sensor(s) to function correctly. The distance between the remote control and the
sensor(s) should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor(s) on the
projector that might obstruct the infra-red beam.
• Operating the projector from the front
19. LIGHT
Turns on the remote control backlight for a
few seconds. To keep the backlight on, press
any other key while the backlight is on. Press
the key again to turn the backlight off.
20. ID SET
Sets the code for this remote control. Press
and hold ID SET until the ID setting indicator
lights up. Enter the ID for the remote control
(between 01~99). The remote control ID
should be the same as the corresponding
projector ID. The ID is saved successfully
when you see the ID setting indicator starts
flickering and then blackout.
21. 3D
Displays the 3D menu.
22. FREEZE
Freezes the projected image.
23. PAGE+/PAGE-
No function.
• Operating the projector from the top
Introduction
9
Advertisement
Table of Contents
