Table of Contents
Advertisement
About this task
The figure indicates the location of the smart card reader board and provides a visual representation of the installation
procedure.
Steps
1. Locate the smart card reader board slot on your computer.
2. Align and place the smart card reader board into the slot on your computer.
3. Install the four (M2X3) screws that secure the smart card reader board to the computer.
4. Connect the smart card reader cable on to the connector on the system board and lock the latch.
Next steps
1. Install the
inner
frame.
2. Install the
WWAN
card.
3. Install the
WLAN
card.
4. Install the HDD.
5. Install the
solid state
drive.
6. Install the battery.
7. Install the
base
cover.
8. Follow the procedure in
50
Disassembly and reassembly
After working inside your
computer.
Advertisement
Table of Contents
