Table of Contents
Advertisement
Problem solving guide
Indicator lights or information in the time display
Problem
The indicator light
lights up at the end of
the programme.
lights up.
Bars flash in the display
at the end of a
programme:
.........
Lines flash and light up
after switching on: .
Programme selection is
not possible.
lights up and
programme start is not
possible.
lights up
lights up
lights up
52
Possible cause and remedy
The tumble dryer is not working correctly or
economically. Possible causes could be clogging
caused by fluff or detergent residues.
To switch off the indicator light, open and close
the door (with the tumble dryer switched on).
Please see "Cleaning and care" for notes on
cleaning.
Clean the fluff filters.
Also check the plinth filter and clean it if
necessary.
You can influence when the indicator light comes
on.
Follow the instructions in "Programmable functions
- Airways indicator".
The programme selector has been moved.
Select the original programme. The time remaining
will appear in the display again.
The programme has finished but the laundry has not
yet cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Access via a code has been activated.
See "Programmable functions - PIN code".
An update is available for the tumble dryer. See
"Programmable functions – RemoteUpdate" for
more information.
This is not a fault. The tumble dryer is connected to
the network.
This is not a fault. The remote control function is
switched off. See "Programmable functions".
This is not a fault. The tumble dryer is connected to
the network.
Advertisement
Table of Contents
