Management Port Leds - Extreme Networks Extreme 7520 Series Hardware Installation Manual

Monitor the Switch
Table 13: System Status LEDs (continued)
LED
PSU Status
Secure
RJ-45 Management Port LEDs
The 10/100/1000Base-T RJ-45 Management port includes two LEDs that are both amber
and green. The LEDs are located on each side of the RJ-45 port. The LED on the right
side is labeled Speed and the LED on the left side is labeled Link/Activity. The following
table describes the meaning of the colors and states for the LEDs.
Table 14: 10/100/1000Base-T RJ-45 Management Port LEDs
LED
Speed
Color/State
Off
Green
Blinking amber
Amber
Off
Blinking blue slowly (1
Hz)
Blinking blue fast (4 Hz) CeC1712 authentication failed.
Blinking blue very
slowly (0.25 Hz)
Blue
Color/State
Off
Green
Amber
Extreme 7520 Hardware Installation Guide
RJ-45 Management Port LEDs
Description
No power.
Power on. Main and Standby output
enabled with no PSU warning or fault
detected.
Warning. Power supply warning
detected.
Fault. Power supply fault.
CeC1712 is booting up or fault. CeC1712
is performing the initial load (decrypt,
validate, load) of its own code, prior to
authenticating images. Or the CeC1712
was unable to decrypt, validate and
load its own image.
CeC1712 is authenticating or
updating images. CeC1712 is currently
authenticating or copying golden
image to primary.
Neither primary nor golden image
successfully validated.
Bypass authentication. Bypassing
authentication for test or
development only.
CeC1712 authentication complete.
CeC1712 successfully authenticated
the BIOS Flash-0 and BMC Flash-0
images.
Description
The port is operating at 10
Mbps.
The port is operating at 1
Gbps.
The port is operating at 100
Mbps.
79