Configuring The Management Interface Via Management Port; Connecting The Data Ports - Extreme Networks ExtremeCloud E2120 Installation Manual

Hide thumbs Also See for ExtremeCloud E2120:
Table of Contents

Advertisement

7 The Appliance Post Installation Configuration Menu pops up right after the last session is applied.
Enter 6 to apply settings and exit or other number for repeating the setup.
8 Connect to a port on which management access was enabled during the CLI Wizard Setup.
9 Launch your web browser and in the browser address bar, type: https://
Your_Mgmt_Ipaddress:5825. The ExtremeCloud Appliance's logon screen is displayed.
10 On the logon screen, enter the Username and Password that was created when setting up the
installation wizard.
Note
An installation wizard is available to help configure the E1120 for new deployments. Refer
to the
information.

Configuring the Management Interface via Management Port

Note
The E1120 must be upgraded to the latest ExtremeCloud Appliance firmware before installing
the appliance on the network.
1
Connect the laptop to the management port of the appliance.
2 Configure the Ethernet port of the laptop with a statically assigned unused IP address in the
192.168.10.0/24 subnet.
3 Launch your Web browser and in the browser address bar, type https://
192.168.10.1:5825 (192.168.10.1 is the default IP address on the appliance's management port).
The ExtremeCloud Appliance's logon screen is displayed.
4 On the ExtremeCloud Appliance's logon screen, enter the following:
1
User name: enter admin
2 Password: enter abc123
3 Click Login.
5 Complete the installation to configure the E1120 for new deployments.
6 Disconnect your laptop from the appliance's management port.
7 Connect the appliance's management port to the enterprise Ethernet LAN.
8 Log on to Extreme Networks.
Note
The system is now visible to the enterprise network. Refer to the
User Guide

Connecting the Data Ports

Data ports 1 and 2 are 1 GbE RJ45 ports.To connect twisted pair cabling:
1
Ensure that the device to be connected at the other end of the segment is powered on.
2 Connect the twisted pair segment to the appliance by inserting the RJ45 connector on the twisted
pair segment into the desired RJ45 port.
ExtremeCloud™ Appliance E2120
Extreme Cloud Appliance User Guide
in the documentation support site for more information.
Initial Network Connection and Configuration
in the documentation support site for more
Extreme Cloud Appliance
12

Advertisement

Table of Contents
loading

Table of Contents