Extreme Networks Extreme 7520 Series Hardware Installation Manual page 58

Two-Post Rack Mount
•
Mid-mount
The side of the switch has different sets of holes for attaching mounting brackets in
either configuration.
Brackets for a two-post mount are not included in the box with the switch. However,
they can be ordered separately using part number XN-2P-RKMT299.
To attach the switch to a two-post rack, follow these steps:
1. On one side of the switch, attach one of the short mounting brackets to the switch
housing.
a. For a front mount, position the bracket over the holes so that the flange (ear) is
even with the front of the switch, as shown in the figure below:
Figure 26: Attaching a Short Mounting Bracket (Ear): Front of Switch
b. For a mid-mount, position the bracket so that the flange (ear) is positioned
slightly more than halfway between the front and back of the switch, as shown in
figure below:
58 Extreme 7520 Hardware Installation Guide
Install the Switch