Installing The Base; Wiring - Bosch FAA-350-B6 Installation Manual

6 en | Installation
Notice!
Make sure the volume of the electrical box you use is can
i
accommodate the number and size of conductors as specified
by the National Electrical Code (NEC) or any local regulations
having jurisdiction.
3.1

Installing the base

Depending on the local regulations, you can surface mount the
base using anchors, mollies, or wing nuts.
1.
2.
3.
3.2

Wiring

Notice!
i
Do not twist the wires or loop them around the terminals.
Notice!
i
When using a separate supply, connect the negative side to the
control panel ground.
1.
2.
2022.09 | 01 | F.01U.396.537
Run all system wiring.
Mount the base using the two oblong mounting holes. Fits 4
in square, octagon, AB, and single-gang back boxes.
Tighten the base to the mounting surface. Tighten until
snug, but not distorted.
Cut, strip, and place the in and out wires for terminal
connection as individual ends.
Connect the power loop to the control panel's switched
auxiliary power.
Smoke detector POPIT base
Bosch Security Systems B.V.