Features Of The App - Parkside PKHAP 20-Li B2 Original Instructions Manual

marks by pressing them.
7. Now press the
colour as the set check mark.
8. Confirm the successful connection with
„Finish".
The device is now listed on the tab
"At home" and can be selected.

If you have already connected other de-
vices to the app:
"At home", select the
4. On the tab
in the upper right. The app scans the
area for available devices and indicates
if available devices have been found.
If this is not the case, read on if

possible
5. Proceed as with

If a list of available devices is not auto-
matically suggested to you:
If the smart battery/device is not suggested
automatically, follow these steps:
"At home", select the
4. On the tab
in the upper right.
5. Select "Other" in the bar on the left.
6. Select „Other-2".
7. Confirm that the display is flashing rapidly.
The app now searches for available de-
vices and suggests them to you.
8. Select the desired device by pressing
the to add it to the app.
9. First confirm with „Next", then with „Finish".
Upgrading the firmware can change
the features of the app.

Features of the app

If you select the smart battery/device, this
will take you to the overview page where you
will find the following information:
- specific device ID
, that has the same
.

from point 5.
- Tool model
- Tool discharge current
- Tool rotation speed
- Tool in Working mode (Operating mode
More power possible with smart battery
than with the Parkside batteries of the
X20V Team series). In expert mode, the
tool rotation speed can be regulated
from 57 % to 100 %. This corresponds
to 540 RPM to 950 RPM.
- Right/left rotation tool
- Lamp switch, for switching the work light
on and off
- Tool illumination brightness, for adjusting
the brightness of the work light
- Tool illumination delay, for setting how
long the work light stays on after the
On/Off switch is released
- Tool total runtime
- Tool overtemperature times
- Tool Lock Times
- Tool overcurrent times
- A red dot next to the firmware version
indicates that an update is available.
The update can be installed by tapping
the firmware version
- Reset to factory settings
Swipe from left to right to reach the smart
battery overview page:
- Lock battery
- Battery Working mode
- PUSH notifications (overtemperature and
battery identifier)
- Degrees Fahrenheit/Degrees Celsius
switchover
- Information
- Statistics
Display in real time as graphs:
- Capacity
- Discharge current
- Charging current
- Temperature
GB CY
15