Side-Discharging The Clippings; Storing The Machine In The Vertical-Stow Position - Toro Recycler 20339 Operator's Manual

Side-Discharging the
Clippings
Use side discharging for cutting very tall grass.
If the grass bag is on the machine, remove it; refer to
Removing the Grass Bag (page
Installing the Side-Discharge Chute
Lift up the side deflector and install the side-discharge chute
(Figure 18).
Figure 18
Removing the Side-Discharge Chute
To remove the side-discharge chute, lift up the side deflector,
remove the side-discharge chute, and lower the side-discharge
deflector.
Storing the Machine in the
Vertical-Stow Position
During the mowing season or in the off-season, you can store
your machine in the vertical position to minimize storage
space.
10).
DANGER
Fuel is extremely flammable and explosive. A fire
or explosion from fuel can burn you and others.
• Storing the machine in the vertical position
when there is too much fuel in the fuel tank
may cause fuel to leak from the fuel tank. Fuel
is extremely flammable and explosive. A fire or
explosion from fuel can burn you and others.
• Store the machine in the vertical position only
when the level of fuel in the fuel tank is no higher
than what is recommended in this Operator's
Manual .
• Do not store the machine in a position that is
beyond the vertical (90°) position; otherwise,
fuel may escape from the fuel tank.
• Do not transport the machine in the vertical-stow
position.
• Do not attempt to start the machine in the
vertical-stow position.
• Do not attempt to store any machine with fuel
and oil in the vertical-stow position that is not
designed for that purpose.
WARNING
g024439
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Ensure that the level of fuel in the fuel tank is no higher
than what is recommended by the engine manufacturer;
refer to the engine manufacturer's decal on the engine
(Figure 19).
Note: If there is the level of fuel in the fuel tank is
too high, drain the gasoline from the fuel tank into an
approved fuel container until it is at or below the level
recommended by the engine manufacturer.
2. Ensure that the cutting-height setting on the machine
is 92 mm (3-5/8 inches) or lower; if it is not, lower it;
refer to Adjusting the Cutting Height (page
11
Figure 19
8).
decal133-8198