Assembling The Grass Bag - Toro Recycler 20339 Operator's Manual

3. Carefully pour about 3/4 of the engine capacity of oil
into the oil-fill tube.
4. Wipe the dipstick clean with a clean cloth.
5. Insert the dipstick into the oil-fill tube, then remove
the dipstick.
6. Read the oil level on the dipstick
•
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat steps
through 5 until the oil level is at the Full mark on
the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick; refer to
the Engine Oil (page
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
7. Install the dipstick securely.
4

Assembling the Grass Bag

No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
1
1. Handle
2. Frame
(Figure 6).
Changing
16).
g027120
3
2
Figure 7
3. Grass bag
Note: Do not slip the bag over the handle
2. Hook the bottom channel of the bag onto the bottom
of the frame
3
3. Hook the top and side channels of the bag onto the top
Figure 7. and sides of the frame, respectively
g027120
6
(Figure 8).
Figure 8
(Figure
(Figure 7).
g027121
g027121
8).