Table of Contents
Advertisement
5. Remove the blade nut, spacer, and
washer. Remove and properly dispose of
the old blade.
6. Install the new blade, washer, spacer,
and nut.
7. Insert a piece of wood into the cutting
deck to prevent the blade from spinning
during tightening the blade nut. Hand-
tighten the nut until the blade is secured
and does not shake.Then use a spanner
to further tighten the nut by 1/2 turn (35-
40 Nm torque).
WARNING: Ensure to remove blade change
lock and place back into compartment before
re-installing batteries to begin mowing again.
5
6
7
2
1
17
Maintenance
Advertisement
Table of Contents
