Toshiba RAV-GM901KRTP Series Service Manual page 61

H1 Readout of the setup data from EEPRO
(Data in EEPROM contents, which have been changed at the local site, are read out together with data in
EEPROM set at shipment from the factory.)
SET CL TE ST
1. Push , and buttons of the remote controller at the same time for 4 seconds or more.
(Corresponded with No. in Remote controller as shown below picture)
∗ When group operation, the header indoor unit address is displayed at the first time. In this time, the CODE
No. (DN) is displayed.
The fan of the second indoor unit operates and the louver starts swinging if any.
2. Every pushing [Unit, Louver
Specify the indoor unit No. to be replaced.
3. Using the set temperature
4. First change the CODE No. (DN) from
Make a note of the SET DATA displayed in this time.
5. Next change the CODE No. (DN) using the set temperature
Also make a note of the SET DATA.
6. Repeat item 5. and made a note of the important SET DATA as shown in the below table.
))
to are provided in the CODE No. (DN). On the way of operation, CODE No. (DN) may skip.
∗
7. After finishing making a note, push
(Approx. 1 minute is required to be able to use the remote controller.)
SET DATA
SETTING
TEMP.
3
TIMER S E T
4
TIME
FILTER
RE S E T TE ST S E T
] button, the indoor unit address in the group are displayed successively.
U NIT L OU VE R
/ buttons, the CODE No. (DN) can be moved up and down one by one.
to
TE ST
button to return to the usual stop status.
CODE No.
UNIT No.
R.C. No.
O N / O F F
FA N M O D E
S AV E VENT
CL S WIN G/ FI X U NIT L OU VE R
. (Setting of filter sign lighting time)
/ buttons.
Minimum requirements for CODE No.
CODE No. (DN)
11
12
13
14
2
Capacity of the indoor unit is necessary to set
1
the revolutions of the fan.
- 61 -
1
2
4
Contents
Indoor unit capacity
Refrigerant line address
Indoor unit address
Group address
3