Replacing Sitrans Cc220; Updating Firmware Of Sitrans Cc220 - Siemens SITRANS SCM IQ Operating Instructions Manual

Service and maintenance
9.1 Maintenance and repair work for SITRANS CC220
Then install the motherboard again and install the top housing.
9.1.4

Replacing SITRANS CC220

Replacing a defective SITRANS CC220
1. Stop anomaly detection models of the SITRANS MS200 assigned to the defective SITRANS
CC220.
2. Replace defective SITRANS CC220 with new SITRANS CC220.
3. Disconnect defective SITRANS CC220 in SITRANS SCM IQ.
4. Connect new SITRANS CC220.
5. Reconnect old SITRANS MS200 with SITRANS SCM IQ to the same Insights Hub asset.
6. Reset SITRANS MS200.
Resetting SITRANS MS200 (Page 62)
9.1.5

Updating firmware of SITRANS CC220

Introduction
If a firmware update is required, you receive a notification in SITRANS SCM IQ.
Procedure
1. Download the firmware update file for SITRANS CC220.
Dowload firmware update file for SITRANS CC220
support.industry.siemens.com/cs/ww/en/ps/28832/dl)
2. Plug in an empty and fat32 formatted USB stick with 16 GB free disk space into your PC.
For USB stick specifications see Table 11-1 USB stick specifications (Page 85).
70
Pull the plug of the battery ca‐
ble from the motherboard.
Remove the battery.
Paste the double side tap on
the battery and then paste it on
the display port socket.
Plug in the battery cable on the
motherboard.
(https://
SITRANS SCM IQ: Smart Condition Monitoring with IIoT Sensors
Operating Instructions, 07/2023, A5E50573389-AD