Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
The fuses are located on the console to the right of
the seat
(Figure
56).
1.
To replace the fuses, pull out on the fuse to
remove it.
2.
Install a new fuse
Figure 56
1. Optional accessory (15 A)
2. Charge (25 A)
3. PTO (10 A)
(Figure
56).
4. Main (25 A)
5. Console
Drive System
Maintenance
Checking the Seat Belt
Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Checking the Roll-Bar
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover, keep
the roll bar in the fully raised, locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
g008966
•
Check that both the mounting hardware and the
knobs are in good working condition.
•
Make sure that the knobs are fully engaged with
the roll bar in the raised position.
Note:
The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to fully
engage both knobs
47
(Figure 57
and
Figure
58).